 |
| |
 |
standards for heat, pull and insulation, making installation easy. They are custom
designed for Insta-Trim Boat Leveler Co., epoxy sealed and humidity resistant,
thereby preventing shorting out. The solenoids lock the tabs in any position,
eliminating driftback. Barb type hose fittings provide tight, secure connections. A
powerhouse with coated wirings and a thermal overload that resists temperature
and amperage build-up. 1 3/4" stack windings and top mounting eliminated oil
leakage. The motor is mounted with stainless steel nuts and bolts, and is easily
disassembled. Swivel type brackets allow cylinders to be mounted an adjusted to
any angle. Knockout pins act as shear pins it tab strikes an object. Designed
and engineered exclusively by Instatrim. The built-in bypass is factory set at 400
P.S.I. tolerance held to .00025. Amperage doesn't exceed 16 because the unit
circulates oil, rather than stalling out or trying to pump additional pressure. 4 1/2"
D x 6" W x 11"H, high impact ABS plastic cover with a built-in oil reservoir mounts
easily with two screws. The filler is located in front. Our cover protects the motor
from occasional wash down. Impact resistant, fiberglass reinforced nylon
cylinders eliminates expansion and resists ultra-violet rays. Two expanding type
seals, plus O-ring, eliminates high and low pressure leaks. Barbed cylinder fitting
and an inserted tubular rod prevents hose blow-off and breakage. A stainless
steel spring retracts the cylinder when the boat is not in motion. 12 gauge 304
stainless steel trim tabs are available in standard and custom lengths. They are
guaranteed against electrolysis, remaining strong and secure. Insta-Trim's
hinges prevent most spray and can be used for transom or bottom mounting.
Designed and manufactured exclusively for Insta-Trim with nylon-reinforced
webbing and protective PVC coating. Rated at 2000 lb. burst pressure, 15' of
hose is supplied for your system. Entering the transom 6" above the water line,
the hoses are held securely with hose trim. Stainless steel clamps hold the hose
to barb fitting at the solenoid. Mounted on the dash they are easy to operate. 2TP
Micro switch with silver contact points adjust the tabs for maximum control and
performance. One pint of Insta-Trim biodegradable transmission oil, funnel and
mounting hardware is supplied.
 |
| |
 |